Professional
Epoxy Flooring
Stillwater, OK

Most residential garage floors in the Stillwater area run between $3–$6 per square foot for a standard epoxy system, depending on the size, condition of the concrete, and finish you choose. Metallic and decorative systems are priced higher. The only way to get an accurate number is to call us for a free on-site quote — we don't do ballpark estimates over the phone because every concrete slab is different.

A properly installed epoxy floor with a quality topcoat will typically last 10–20 years under normal residential use. Commercial floors under heavy traffic see more wear, but with the right product selection and prep work, you can still expect years of reliable performance. The number one factor in longevity is how well the concrete was prepared before installation — which is why we don't skip that step.

Most two-car garages are completed in a single day. We arrive, diamond grind the concrete, apply the base coat, broadcast decorative chips or metallic pigment, and apply the topcoat — all in one visit. Light foot traffic is typically possible within 24 hours. We recommend waiting 72 hours before parking a vehicle on it. We'll give you the full rundown at the end of the job.

Usually, yes. Minor cracks can be filled and prepared before coating. Oil stains are addressed with proper degreasing and prep. There are limits — severely damaged or actively settling concrete is a different conversation — but most standard residential slabs are totally workable. We'll assess your concrete during the free estimate and give you an honest read on what's possible.

Yes — the entire floor surface needs to be clear for installation. Vehicles should be moved out, and items along the walls or on shelves directly over the floor should be relocated or covered. We handle the rest. Plan to keep the space clear for about 24–48 hours after installation to allow proper curing time before you bring everything back in.

The difference comes down to surface prep and product quality. DIY kits apply over unprepared concrete and use thinner formulations — they look fine for a season or two, then peel. We mechanically grind the concrete to create proper adhesion, then use commercial-grade epoxy and polyurea topcoats that bond to the slab rather than sitting on top of it. The result lasts years instead of months.